Jump to content


Photo
- - - - -

Rotary encoder settings on new UWTechnics TTL converter?


  • Please log in to reply
2 replies to this topic

#1 mackman

mackman

    Starfish

  • Member
  • Pip
  • 8 posts

Posted 16 April 2018 - 04:17 AM

Hi, just replaced my non-TTL converter with a TTL one. The new one has a rotary encoder with 10 or 16 (I forget) possible settings, but the included instructions refer to having two switches with 4 possible settings. Anybody know where I can get the correct rotary encoder settings for Inon Z330 strobes? Thanks, Ryan



#2 mackman

mackman

    Starfish

  • Member
  • Pip
  • 8 posts

Posted 16 April 2018 - 04:23 AM

Just to clarify, this is the Nauticam 26308 designed by UWTechnics for the D5/500/850. Instead of the two little switches, it has a little rotary dial. I'm guessing if the switches are both supposed to be off for the Z-240s then the dial should be at 0 for the Z330s, but it would be good to see the official answer. Thanks again, Ryan



#3 Pavel Kolpakov

Pavel Kolpakov

    Wolf Eel

  • Industry
  • PipPip
  • 155 posts
  • Gender:Male
  • Interests:UNDERWATER PHOTO

Posted 20 April 2018 - 08:34 AM

Hello Ryan,

 

Rotary switch positions are following:

 

0 - Manual mode (TTL protocol is switched off)

1 - Z240, Z330

2 - YS-D1

3 - YS-D2

4 - YS-250

5 - DS161, DS160