Jump to content


okuma

Member Since 20 Feb 2006
Offline Last Active Yesterday, 07:26 PM
-----

Posts I've Made

In Topic: Seeking Tips for Shooting Video of Hawaii Manta Night Dive

13 June 2018 - 07:51 PM

It will be you and 150 other divers in a big circle at about 40'.

Lots of strobes firing, video lights waving around and squids kicking up the bottom.

Still, a marvelous happening - sit back and enjoy the action :good:


In Topic: Lens stuck on Nikonos III

01 June 2018 - 10:43 PM

To insure vacuum is not a problem, remove flash cable/plug .

Remember to replace before submerginp again.


In Topic: Nauticam rx100m2 housing no bulkhead for vacuum

22 May 2018 - 11:34 AM

Take your housing and vacuum unit to a local machine shop and tell them you need it to be drilled, tapped and spot faced fo your vacuum unit.

Or send it to Reef Photo & Video. They advertise on this site!


In Topic: Looking for advice on 3D-printed zoom gears

16 May 2018 - 08:59 PM

There is minimal torque on a lens ring and don't worry about tooth design and pitch diameters..

For a couple of bucks, look at this:

https://www.ebay.com...675.m4096.l9055


In Topic: Anyone using Sea&Sea Buoyancy Handle (Plastic)

14 May 2018 - 07:17 PM

Hand made from  Divinycell foam.

Folds flat with standard ultralite clamps.

Cut to neural float Subal/NikonD500/2xInon 240z strobes.

Cost - $US20, less clamps..Attached File  4.jpg   519.38KB   7 downloadsAttached File  5.jpg   465.8KB   5 downloads