Jump to content

- - - - -

Replacing Nauticam Dome O-ring

  • Please log in to reply
2 replies to this topic

#1 mr.reznovich



  • Member
  • Pip
  • 8 posts
  • Gender:Male

Posted 07 February 2019 - 12:32 AM

Hi everyone,


I just got a new o-ring for my Nauticam acrylic 8.5 inch dome as the old one was cracked and led to some minor leaks (just few drops) inside the dome.


Just to clarify I'm talking about the black o-ring that seals the acrylic dome to the Port, and not the grey o-ring that simply seals the port to the housing. I have never changed this type of o-ring before, can anybody help with some directions, tips or particular techniques I should use when changing it?


Thanks in advance

#2 Bthomasphillips


    Sea Nettle

  • Member
  • Pip
  • 12 posts
  • Gender:Male

Posted 30 April 2019 - 02:03 PM

You can contact Reef Photo in Fort Lauderdale to get an o ring replacement

#3 synthetic


    Sting Ray

  • Member
  • PipPipPip
  • 206 posts
  • Gender:Male
  • Location:Glendale, CA

Posted 12 May 2019 - 03:34 PM

I haven't replaced that on a Nauticam but I have on Ikelite which I assume is similar. The only tricky thing about it was that the thread was very fine, so be careful not to cross-thread that. You might need a pipe wrench to remove the ring from the port. 

Jeff Laity -- Underwater Gallery
Canon 5Dmk4, Nauticam Housing, Inon Z-220 strobes