My Symbiosis flash or my camera is giving me a hard time - I hope you can help me figure out, what is wrong.
My setup is a Sony A6300 and Symbiosis SS-2 flash. I run everything manual, and using fiber flash cable between the housing and the Symbiosis. Everyting is running great, as long as I don't turn the Symbiosis power over 11 (the range is from 1 to 15). When the Symbiosis is set to 12 or above, the flash fires - but the camera "does not see the light" from the flash (the picture is dark). I have tried a lot of different settings in my camera, but no luck so far.
Does anyone have any ideas as to what is causing this? I have tested this with a Sony RX camera also with the same result. On my old Canon G15, it works fine. It seem as if Sony and Symbiosis is not a great match - or hopefully it's just a little tweak in my settings, that will fix everyting.
Any help is greatly appreciated.
Thanks in advance.