Jump to content


Photo
- - - - -

Forgot to affix strobe cap to Ikelite housing for a dive...

help advise

  • Please log in to reply
2 replies to this topic

#1 Alex Brown

Alex Brown

    Sea Nettle

  • Member
  • Pip
  • 11 posts

Posted 30 March 2013 - 02:34 AM

Hello,

 

I was wondering if anyone might be able to advise me on my little hiccup today... I forgot to put the strobe cap on the housing, for where the cord screws onto the housing body of my Ikelite 7D setup. I only noticed I had not put the cap on at 20m :(

 

Are there any methods for ensuring the port is completely clean and salt free? I would be so upset if the strobe port contacts corroded from my error.

Thanks, Alex.

 

The port I am talking about looks like the one of the left (on the housing).

 

bh-ike-ike.gif



#2 blibecap

blibecap

    Tiger Shark

  • Member
  • PipPipPipPip
  • 537 posts
  • Gender:Male
  • Location:Cincinnati, Ohio U.S.A.

Posted 30 March 2013 - 06:18 AM

Hi Alex

My suggestion would be to soak the strobe connector in distilled water for as long as possible and agitate the water occasionally. It will need to soak long enough to dissolve any salt residue and dilute any salt water that may still be in the connector. Then allow it to completely dry out before you install the cap. 


Bill Libecap
Cincinnati, Oh
http://www.UwCameraStuff.com
Home of the Housing Sentry, the ultimate leak prevention system.

#3 Balrog

Balrog

    Eagle Ray

  • Member
  • PipPipPip
  • 346 posts
  • Gender:Male
  • Location:Poole UK

Posted 30 March 2013 - 06:33 AM

I did the same thing. Got under to find the cable and housing not connected.

There was some corrosion/missing plating on the pins, presumably electrolytic action. I just flushed well with fresh water, dried thoroughly and put a smear of copper grease on the pins to ensure a good contact in the future. 

 

Still working fine 3 years later :)







Also tagged with one or more of these keywords: help, advise