Jump to content


owfotograaf

Member Since 30 Jun 2007
Offline Last Active Yesterday, 06:46 AM
-----

Posts I've Made

In Topic: air filled dome diffuser

01 February 2017 - 02:16 AM

yes ... you can see the T shape without diffuser ... thats why i like strobes with ring flash tubes

Verstuurd vanaf mijn GT-I9505 met Tapatalk

In Topic: air filled dome diffuser

03 January 2017 - 03:29 AM

the air filled dome is seperate filled with air and sealed. There is a gap from 3mm between the strobe and diffuser that is filled with water. installing the diffuser is very easy and stable ... fixation with 4 screws in pvc.

Verstuurd vanaf mijn GT-I9505 met Tapatalk

In Topic: air filled dome diffuser

28 December 2016 - 07:02 AM

My opinion .. the air filled diffuser is the widest and softer, no loss of strobe light.

Pics are not edited!

Grts, Hedwig.

strone = strobe :P

1 tile = 20cm

 

 

Attached File  AirSealedDiff1.jpg   48.09KB   34 downloads Attached File  InonDiff1.jpg   45.86KB   32 downloadsAttached File  NoDiff1.jpg   43.92KB   35 downloads

Attached File  AirSealedDiff2.jpg   48.22KB   34 downloadsAttached File  InonDiff2.jpg   42.74KB   37 downloadsAttached File  NoDiff2.jpg   48.36KB   36 downloads


In Topic: air filled dome diffuser

19 December 2016 - 10:30 AM

I have bought one for a test in the pool ... but it is now on hold in customs ..
I will do a setup with the Inon z240 and post a reply and pics.

Verstuurd vanaf mijn GT-I9505 met Tapatalk

In Topic: Little micro strobe batch!

20 August 2016 - 09:25 AM

Still making them and ..... shooting at 4fps and 1/320

DIY PROJECT ....

if you have the space in your housing and want to use led's that consume more then 20mA (limited now by the CR2032 battery's)

.... you can fabricate this ... i use it now with D810 in Hugyfot housing. Don't forget to put a resistor serial with your led, in this case 39ohm with white and red led!!!!

... although no difference in sensibility between red and white on Sea&sea and Inon strobe. Most off the sensors are in the 600nm range, so red is the best to use.

 

 

ALSO very important: the fiber and led are aligned straight and the surfaces of the optical connector are FLAT on booth sides.

Greetings, Hedwig.