gillie

The Intova 2000 is a basic strobe. I sold a slightly updated model for about a year from UltraMax the OEM. It is manual only with 4 power settings.

Reports from users were that it was ok, but it only has a 60 degree beam and is bulky and very buoyant.

The 2000 is an older design. It does not have a sealed battery compartment, if it floods, it's toast.

I would look at a better strobe. If you want TTL there is also the new Sea & Sea YS-01, much wider beam angle, power, adjustablity and a target light.

Jack

I am using the 2000 at the moment, No TTL capacity, just fibre optic trigger, using it with a Canon G9 in the ikelite housing and the whole deal is just slightly negative in the water, the battery cap is well sealed with 2 O rings, when for a dive on the weekend to 23mtrs and after the dive found i had left the cap only half screwed in, but no water entry into the strobe. It has been a good package for me to start with on the Canon housing but now i have TTL capacity i might start looking at a better strobe :-)

Hi guys, I am looking to buy a cheapish 2nd hand Ike housing for my Gf's G9.

Many thanks

Hi Tj, i have just picked one up from backscatter in the states for $459USD

http://www.backscatt...p;ftn=youbetcha

i attempted to embedd the image just above this using the code

it appears to me that the images are not able to be linked to outside sites, the embed code it gives is as follows and the image doesn't show from it

Many thanks for the help, can you recomend another site to store images?

brackets changed to let it be seen

You've done it right but your address must be wrong for some reason, I cannot access your photos due to limited internet access, I saw your home page, is it the lionfish portrait on there? http://images.gillie1.multiply.com

Yes thats where it is, thanks.