Jump to content


Pedda

Member Since 26 Jun 2004
Offline Last Active May 18 2012 05:07 AM
-----

Posts I've Made

In Topic: Removing oxid

01 April 2008 - 09:58 AM

Thanks for your answers.

The only thing is that I'm a little bit afraid that the ultrasonic cleaner will "take away" to much of the material so that the o-ring will seal bad.

Regards

Peter

In Topic: Fish funnies

16 January 2008 - 08:42 AM

Here is my contribution to funny fish faces.

// Peter

In Topic: Hang Time

15 January 2008 - 08:46 AM

Very nice sun burst. What lens and settings?



Hi Larry,

I've used the Tokina 12-24 f/4 AT-X PRO DX lens for this shot.

Exposure settings: f/14.0, 1/250 seconds

// Peter

In Topic: Broken Ike D200 housing

15 October 2007 - 01:16 PM

Peter,

I bought the backup set, which consists of an entire mix of these. I would be willing to send you a clip. But since it is almost tomorrow now , and I am in the netherlands, it will never get to you in two days.

You could also exchange the eclip from a less used button, and then use a cable tie (tywrap) to secure it. The eclip is there so it wont get out of the housing.

I tried looking for an eclip in generic stores (for a "vieux" french regulator I got somewhere, but i think it will be especially hard to find a proper size (also becaue of the inches vs cm-etrs

Gerard


Thanks for you help, but as you said it's not enough time for the snailmail to reach Sweden.

/ Peter

In Topic: Broken Ike D200 housing

15 October 2007 - 12:53 PM

I found a picture on the internet of the part that I need to get hold of.

/ Peter