Apologies if this is a stupid question..
I recently purchased a pair of DS-160's.. My question is, if I want to use the strobes in full manual mode, (i.e adjusting strobe outputs indiviually on each strobe), how do I do that? On the strobe itself? Or the housing conversion circuitry? I'm currently shooting a 5D2 in an Ikelite housing..
When the housing circuitry is set to manual, I get to adjust the flash output there, but does it asjust output for BOTH strobes, or just the master?
Completely lost as to how to manage this..
Thanks for your input in advance!!
nivla80Member Since 19 Oct 2010
Offline Last Active Jun 29 2012 12:23 PM
- Group Member
- Active Posts 2
- Profile Views 655
- Member Title Sea Wasp
- Age Age Unknown
- Birthday Birthday Unknown
Show Country Flag: