Jump to content


rrodex99

Member Since 03 Mar 2012
Offline Last Active Yesterday, 11:00 AM
-----

#337867 Macro ring flash

Posted by rrodex99 on 07 October 2013 - 01:20 PM

Here is my latest take on this topic.

I have played around with acrylic light pipes but as the density of acrylic is close to that of water I reasoned that the effectiveness would be much reduced. My concept is a piece of 20mm acrylic with appropriate edges cut at 45 degrees in prisms to take part of the inbuilt flash output and distribute it to the two bottom corners around the housing. To achive total internal reflection I needed to put small covers over each reflective surface to achieve an acrylic/air face.

I made this for a friend's housing and only took one underwater photo before handing it over, but am making a second unit for myself which will sit inside a diy housing.

Photos show the unit on and off the camera, and photos with and without the unit. As it is held on by the original diffuser it can be easily fitted and removed underwater and uses the camera's TTL metering.

 

Rod

 

 

IMG_3_zps3a543c85.jpg

 

 

IMG_2_zps925c81c1.jpg

 

 

IMG_1_zps3fc710a7.jpgIMG_4_zps4377a72b.jpg