Jump to content


Member Since 23 Oct 2012
Offline Last Active Dec 31 2017 03:53 AM

#340453 Olympus PEN & OMD Flash mod to reduce recycling time & battery

Posted by AYahoo on 09 December 2013 - 12:28 PM

Hi Nir, the E-PL3 does output pre-flash, I have it tested, and I will post some of the findings later.

#331782 3D Printing a port

Posted by AYahoo on 23 May 2013 - 07:44 AM

OK! So it took around 7 hours to complete the assemble, but once it was ready, All I had to do was, load the software, set the fill to 100%, and press PRINT.


didn't change any of the defaults, just tried to print and see..


ACTUALLY, it was AMAZING. I was sitting looking at the printer for an hour, and after an hour, 3 parts were sitting there on the build platform!


the results are "OK", not the best ever, but surprisingly much better then my expectations.


now I need to start and print some good stuff :).




Attached Images

  • 2013-05-23-18.31.jpg

#331480 3D Printing a port

Posted by AYahoo on 16 May 2013 - 11:23 PM

Hi All, I just bought a new 3d printer (didn't get it yet :)), but I wanted to ask if anyone has ever tried to print a PORT with the printer. I know ABS plastic is strong enough. and the 3d printer should be accurate enough, so theoretically speaking I should be able to print a port.


Any thoughts?