jamsys

Purchased the small FishEye LED and need something bigger.. Anyone???

Let me pose a question... What happens old equipment with either policy. I have a Fuji S2 in a Subal w/ SB105's... I realize they prob could find a S2, but since it does analog TTL if they couldnt replace it my SB105's would be worthless. And if they cant find a Subal housing??? Lots of if's, but I am curious how that would be handled, since my equipment is pretty much a package deal Scott

Pics??

SUPER-WIDE 6” DOME PORT For lenses with a 110 to 170 degrees angle of coverage. This port does not allow use of a port shade. #5503.15 Lens less than 2.5” (6.30cm) 9/10 --------------------------------------- Sync cord For Nikonos Strobes SB 103/104/105 with Ikelite dSLR Housings #4116.31 Single (NEW AND #4116.32 Dual (Used) Contact me with offers and questions Thx! Scott

Bump

Is this still available??? Scott

Still Available?

I am selling my Ikelite Fuji S2 Pro housing as I switched to Subal The hotshoe and bulkhead connector needs replacing (approx $150 per Ikelite) and prob a annual service Fuji S2 Pro's are still available from KEH for about $200.00 Or pick it up for parts for your other Ikelite housing! Make me a offer Scott

#5503 ........ 3.1” (7.85cm) 7/10 - SOLD

Walt Sent you a PM Scott

I have the following Ports and Cables for sale Dome Ports #5503 ........ 3.1” (7.85cm) 7/10 #5503.50 ... 4.1” (10.4cm) 9/10 SUPER-WIDE 6” DOME PORT For lenses with a 110 to 170 degrees angle of coverage. This port does not allow use of a port shade. #5503.15 Lens less than 2.5” (6.30cm) 9/10 --------------------------------------- Sync cord For Nikonos Strobes SB 103/104/105 with Ikelite dSLR Housings #4116.31 Single (NEW AND #4116.32 Dual (Used) Contact me with offers and questions Thx! Scott

Ok, I think this one is solved... Fred @ Backscatter (such a great guy) has me ohm out the pins.... Looking closely, the blue wire (sync) was severed where it wraps around the plastic clamp right before it connects to the circuit board.... I think its a bad design, but oh well... It is going back to him as I dont want to mess with soldering a cut wire Hopefully that will fix it Thx to all that responded....

Drew, I just checked that, and it does have the selectable config. It is set on TTL (5 pin). The previous owner shot w/ DS-125's from Ike, which are Analog TTL compatible... Fred @ backscatter is stumped as well... I was hoping not to have to send the housing in for repair

A update. I went to helix in Chicago and we verified multiple sync cords, SB-105's and bodies. The camera will sync with a land flash, as well as the internal flash. The previous owner used Ikelite flash's... Again, they will fire, just not sync or give me a flash ready HELP!

Drew, When you say switching to manual, do you mean in the subal housing??? Confused