Search the Community
Showing results for tags 'EM1Mk2'.
Found 1 result
-
Been using my Olympus 60mm lens and original EM5Mk1 for a few years now. It works fantastic on land and underwater. When I dive with it I set the limiter to the 0.9-.4m setting which makes focusing performance better. This works great with the now older EM5. However, with my new EM1Mk2 the focus limiter doesn't work. On autofocus the lens hunts throughout the entire range. It doesn't matter where the limiter is set, it cycles through the entire range on the EM1. The limiter works properly on the EM5. The lens and both camera bodies are all updated with the latest firmware. A lot of times with the EM5 I would use manual focus and just rock the camera back and forth to find the focus. However, sometimes I would use autofocus and place the focus point right where I wanted it. This usually worked very well and focus was quick with the EM5. However, with the EM1 the focus hunts back and forth throughout it's entire range and sometimes takes a while to find focus. I can replicate the same behavior on land as well. With the EM5 the focus limiter works as intended; however, with the EM1 it is as if the limiter is ignored. Has anyone else dealt with this? Have I missed a setting on the EM1Mk2 that disables the limiter? I looked through the manual but cannot find a mention of the limiter.