Jump to content

Search the Community

Showing results for tags 'Inon knb'.

More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


  • Administration
    • Announcements
    • Feedback
  • The Galley
    • The Galley: General Chat
    • Beginner Forum
    • Photo / Video Showcase
    • Classifieds
  • Gear and Tips
    • Photography Gear and Technique
    • Video Gear and Technique
    • Lights, Strobes, and Lighting Technique
    • Shooting Technique, Workflow and Editing
  • Planet Earth
    • Trip Reports and Travel
    • Conservation and the Environment
    • Critter Identification
  • Other
    • Copyright Issues, Non-Payment, Fraud, Theft

Find results in...

Find results that contain...

Date Created

  • Start


Last Updated

  • Start


Filter by number of...


  • Start




Website URL






Full Name

E-mail Address

Contact Phone

Mailing Address

Camera Model & Brand

Camera Housing

Strobe/Lighting Model & Brand


Industry Affiliation

Found 1 result

  1. A while ago I downloaded an .stl file from Thingiverse for an Inon strobe knob. I had the knob printed and used it for a few dives in cold water with thick gloves. It was absolutely no problem to operate the strobe knobs with this add-on, BUT: The knobs had a tight fitting in the beginning, after 10-15 dives they lost friction, and I lost two of them. Next time I will use some silicone (I am a dentist and have access to low viscosity silicone...) to give them a better friction. And there is something else that - IMHO - could be improved: As you can see in the attached picture, the "arrowhead" of the knob is quite small. I wish it was bigger, like in the "Photoshopped" version on the right side of the pic (with a quick glimpse you could see more easily to what position the knobs are set). The file is no longer available on Thingiverse, and I cannot find any contact infos for the uploader, Grega VerĨ, to ask him for a modification. I have absolutely zero experience with 3D modelling or how to modify the .stl-file, Is someone here whom I might bother to ask to do this for me - and others, of course? I attach the .stl-file; hope it is not against any netiquette and there is no copyright trouble (as far as I remember, the file was offered under a CC license, and I used it just for me, strictly non-commercial)? To flatten the top of the knob or not is just personal taste. Regards, Jock INON-knob.stl.zip
  • Create New...