Search the Community
Showing results for tags 'service'.
Found 3 results
Is there anyone that can help me with information/guides about what o-rings, springs etc that is used for the Sea&Sea mdx-d500housing? I’d like to service it myself since I’m travelling to places like Lembeh. It doesn’t make sense to send it in for service after each trip to get rid of all the sand in the buttons. I know that some of you would like to avoid me from doing it myself but come on, It’s not rocket science how to do remove and replace parts. And you also have the vacuum system to help you detecting any leakage problem. Anyone? Private message me or reply to this topic. I guess more ppl might be interested.
Unfortunately one of my Inon Z240 is acting up, and this just a week from my trip to the Philippines. It seems not be working in manual or full mode - it fires but seems to be stuck at the same low output regardless what the output dial is set to. The magnet is in, so ACC should be off. When in STTL-LOW it seems to work, the output changes depending on the camera's flash power. I know there has been some issues reported with the magnet being corroded on the Z240s, so I removed the push button to have a look. The magnet seemed OK - didn't see any obvious corrosion - but it was loose and not attached to the button. Very well, attached it yesterday and retried – same issue. Since I have another Z240 that is working, I tried to switch the push buttons just to see if that made any difference. Unfortunately the issue remains. The second Z240, which was was working fine before, is still working with the other Z240s push button/magnet in place. Some quick facts: * Olympus OMD EM-5 * Nauticam housing * Optical flash trigger, use the OMDs flash to trigger (set to manual, as low as possible) Not sure what else to do, is shipping for service the only option left? I'm going to Hong Kong just before my Philippines trip staying for a few days, does anyone know of a Inon service center that might have a look in-house? Many thanks!