segal3 0 Posted February 2, 2006 Would it be possible for any of you with Seacam housings to take a few photos of the (inside and outside) of the back as the viewfinder is assembled/removed from the back? I would greatly appreciate it. PM is fine as well. Share this post Link to post Share on other sites
3@5 0 Posted February 2, 2006 sorry matt, gear is all packed as i am leaving tomorrow, if no one else can provide in the mean time i will try and do while in lembeh and post some photos then... one key thing is:never forget the clips (not sure if that is the right name for that circular item) on the inside of the housing that secures the viewfinder... Share this post Link to post Share on other sites
kcf955 1 Posted February 3, 2006 See if this helps: Seacam Viewfinder Change Out Notes in: #4 Use one finder of one hand to hold the delrin ring in place, with the other hand use a finger to pry the other half of the delrin ring out of its grove. #9 When putting the viewfinder back make sure it is fully seated against the housing. This will ensure the delrin snap ring gets into the grove in #10. Keith Share this post Link to post Share on other sites
Giles 1 Posted February 3, 2006 Matt what are you trying to make now ? Share this post Link to post Share on other sites
kcf955 1 Posted February 3, 2006 I think it is a "Seacam-a-ikelite" Ikelite front half of housing w/ Seacam back half....best of both worlds Share this post Link to post Share on other sites
