Alastair 2 Posted September 16, 2010 I am looking at the Fisheye housing for my wifes G11 - i have a YS-90DX that i used to use and is still in good condition - can it be used with a fibreoptic cable from the Fisheye (or any) housing? I want to replace it with a Inon later but just to get going..... And if i do use it with fibre optic will i get TTL exposure? thanks.. Share this post Link to post Share on other sites
pmooney 6 Posted September 16, 2010 Yes - you could use this with the G11. The strobe just needs to be switched to SLAVE ON. No - you wont get TTL with this combo. Share this post Link to post Share on other sites
Alastair 2 Posted September 20, 2010 ok thanks. For TTl exposure is there a recommended strobe? Inon 2000 or Z240? Share this post Link to post Share on other sites
onewolf 2 Posted September 25, 2010 ok thanks. For TTl exposure is there a recommended strobe? Inon 2000 or Z240? My wife likes her dual S&S YS-01s with the G10/Fix. She was going to get the Inon S2000, but then S&S released the new YS-01 strobe and it has built in focus light which the S2000 does not. Share this post Link to post Share on other sites
ChrigelKarrer 52 Posted September 26, 2010 The Inon D-2000 has a built-in focus light, automatic mode, 2 strobe tubes and work perfect with the G11. Chris Share this post Link to post Share on other sites
Alastair 2 Posted October 6, 2010 thanks all... until bonus time (if) i will still be using the YS-90 - how do i attach the L-connector on the fibreoptic cable to the slave sensor on the fornt of the flash? thanks again.. Share this post Link to post Share on other sites
