KirkD 7 Posted December 23, 2012 I was just curious if there was a way to prevent corrosion? Does anyone put any thing on the screws? Is there a good way to clean it off? Also, I just recently did my first much diving and man, there is sand in every grove. Any recommendations on how to handle this? Thanks Kirk Share this post Link to post Share on other sites
blibecap 28 Posted December 24, 2012 I use this product to prevent corrosion. http://www.tefgel.com/contain.php?param=tefgel_infor Share this post Link to post Share on other sites
bvanant 167 Posted January 1, 2013 We use Lanacote on the screws for both housings and tripods (Per xIT instructions) but tefgel also works great. Make sure you have a good sacrificial anode on the housing. Bill Share this post Link to post Share on other sites
JackConnick 74 Posted January 2, 2013 (edited) Here's a link to my blog article on o-ring maintenance. If you can take a milk jug of water to your dives and rinse immediately, it can really help. Underwater Camera Floods: Avoiding the High Water Mark Edited January 2, 2013 by JackConnick Share this post Link to post Share on other sites
KirkD 7 Posted January 2, 2013 (edited) Here's a link to my blog article on o-ring maintenance. If you can take a milk jug of water to your dives and rinse immediately, it can really help. Underwater Camera Floods: Avoiding the High Water Mark http://opticalocean.blogspot.com/2007/12/underwater-camera-floods-avoiding-high.html Edited January 2, 2013 by KirkD Share this post Link to post Share on other sites
