Jump to content

Recommended Posts

Hey guys,

 

Proud owner of a S&S DX-2G with YS-01 strobe, which have both served me well for years. After all this time, I've noticed though, that the O-Rings on the arms (S&S arm 7) are starting to get very brittle. Just to be clear: I am talking about the thick O-Rings that help stabilize the joints of the arm in a certain position.

 

Now I'd like to replace those sooner rather than later, and preferably before I get to Bali in August. Does anyone have any idea, where I might be able to purchase a set of those 4 O-Rings? I've gone through plenty of sites and online retailers, but they all only seem to offer replacement O-Rings for the strobe itself, not for the arm though...

 

Any tips or advice welcome! Cheers for the help :)

post-24952-0-35336600-1529348329_thumb.jpg

Share this post


Link to post
Share on other sites

i bought a 100 off ebay for ULCS arms about a year ago. Check ebay out.

Share this post


Link to post
Share on other sites

can you remove one and measure it or at least take a picture of it next to a good mm scale?

thanks

Bill

Share this post


Link to post
Share on other sites

Ha, now there's an idea!

 

I did manage to take one off without ripping it. I measured 28mm in diameter with a strength (thickness) of 5 mm. The ones you linked on amazon seem a little bit smaller, with a diameter of 24mm and a strength of 3,5mm. But based on my measurements, I'll see what I can find online.

 

Thanks, you have been very helpful! :)

post-24952-0-79718400-1529407281_thumb.jpg

Edited by Zyndell

Share this post


Link to post
Share on other sites

Sponsors

Advertisements



×
×
  • Create New...