Samir.singh 0 Posted April 13, 2019 Hello fellow divers-photographers, I recently purchased an I-Das TR-03 tray along with a pistol handle ball mount grip, also by I-Das. I am having some problems with the screw in connection and was hoping for some advise. The pistol handle screw at the bottom (see attachment) tightens to a maximum point on the bottom of the tray yet still, the handle grip has some movement on the top, is this normal? Secondly, I cannot tighten the screw at the bottom any further as both the screw and the handle grip start to move together. Is this normal too? Anyone facing a similar issue and what does one do to resolve it? I was thinking a thin washer, where the handle connects on the top part of the tray might help but not sure if this will solve the problem. Any advise appreciated. Thank you kindly excuse the Cantonese/Mandrin print on the sheets Share this post Link to post Share on other sites
Samir.singh 0 Posted September 19, 2019 Added a second washer and solved the issue. Figured the handle screw was turning the entire unit since it's height was just a mm above ideal. Share this post Link to post Share on other sites