Jump to content
mborosch

FS Custom Tripod Plate for Housing

Recommended Posts

FS Custom Tripod Plate for Housing

This was a custom made tripod plate, that I used with my Aquatica 5D MKII housing, I’m pretty sure it will work with most housings.

$100


Please feel free to ask any questions, buyer pays shipping and insurance. I will take PayPal but will only ship to registered PayPal address.



Thanks
Mark

post-22256-0-36615300-1562158422_thumb.jpg

Edited by mborosch

Share this post


Link to post
Share on other sites

What are the dimensions of the plate? What material is it?

What is the distance between the center of the left horizontal slot and the right horizontal slot? 

What is the distance between the center of the top vertical slot and the bottom vertical slot? 

 

Share this post


Link to post
Share on other sites

I have the plate stored at another location, It may take me a couple days to get the measurements.  I'll message you back once I have the info for you.

Thanks

Mark

Share this post


Link to post
Share on other sites

Here's some photos with a ruler laying on top so you can see the measurements yourself.  I believe it's anodized aluminum.  It will cost about $15 using a USPS flat rate box.  If you have questions you can call me at 813-781-9368 or email me at mark@borosch.com

 

Thanks
Mark

 

IMG_4332.jpg

IMG_4333.jpg

Share this post


Link to post
Share on other sites

Sponsors

Advertisements



×
×
  • Create New...