Jump to content

Recommended Posts

Does anyone have any idea what type of paste to secure wires in a housing with? The clip in my Nauticam housing seemed to be secured by a paste, and it has come loose. Any ideas out there?

Help!

Diving mama

Share this post


Link to post
Share on other sites

You're talking about the wires for the leak sensor correct? All that is doing is keeping them from getting in the way of putting your camera in. If it is a clip that is glued on I would try some double sided tape to stick it down, You could use silicone but it's really hard to be neat with that in the confined space inside your housing.

Share this post


Link to post
Share on other sites

Like Chris, I used double-sided tape to secure the electronics of a leak detector and it’s cabling inside a housing. Easy to apply, neat and tidy, seems resilient and easy to remove.

Share this post


Link to post
Share on other sites
Posted (edited)

When mine came loose, I used a dab of Gorilla Glue... It seems to be a thick consistency, water proof contact cement.

 

BTW, Reef Photo recommended epoxy.

 

HTH

Edited by echo2600

Share this post


Link to post
Share on other sites

Thanks so much everyone! Nice ideas. Think I'll use the tape and see how it goes. Was worried it would be hard to remove the clip if Gorilla glued and electronics needed replacing....hopefully not!

All the best,

Divingmama

Share this post


Link to post
Share on other sites

Sponsors

Advertisements



×
×
  • Create New...