Harin 1 Posted October 4, 2019 I have the ultralight tray seen below and is wondering what the vertical extension piece is suppose to do? What is the benefit of having the short extension part being at an offset? Share this post Link to post Share on other sites
Interceptor121 549 Posted October 4, 2019 In case you need to put your hand there for ergonomics Share this post Link to post Share on other sites
Tom_Kline 130 Posted October 4, 2019 ULCS sells grips that go in the round hole. Possible to put one on each side. One can be lower than the other - good for even more accessories to go on top and not be too high. Share this post Link to post Share on other sites
Harin 1 Posted October 4, 2019 3 hours ago, Interceptor121 said: In case you need to put your hand there for ergonomics I see, thanks. My hand tend to be on the upper part of the grip because that's where the trigger on my housing is. I guess there are some housing that would require space near the bottom. Share this post Link to post Share on other sites
tursiops 81 Posted October 5, 2019 The tray can be used with the add-on piece on the left ir the right, whatever works best for you. Share this post Link to post Share on other sites
