Jump to content
Grug

FS: Ikelite 4401.1 Fiber Optic Converter for DS Strobes

Recommended Posts

Selling a MINT condition Ikelite 4401.1 Fiber Optic Converter for DS Strobes. Only used for a week of diving, so it's in fantastic knick.

 

Ikelite's spiel below:

Converts the electrical bulkhead of any Ikelite DS strobe into a fiber optic port. The Fiber Optic Converter features heightened sensitivity for use with SEA&SEA or Nauticam housings with internal electrical-to-optical flash triggering devices. These devices translate the camera’s electrical signals into a series of LED flashes which are much less bright than a traditional built-in camera flash. The Fiber Optic Converter is also compatible with any system where the camera’s built-in flash can be seen by a fiber optic cord.

The Fiber Optic Converter automatically configures itself for compatibility with both pre-flash and non pre-flash camera modes. No setting of small switches or confusion over number of pre-flashes. Simply turn on your strobe and take one picture to configure. This adapter is a manual exposure (non-TTL) trigger only. The strobe’s output may be adjusted using the manual power settings built into the strobe (varies by model).

An individual Fiber Optic Converter and compatible cord is needed for each strobe. Use of two strobes requires two Fiber Optic Converters. The Fiber Optic Converter supports DS50, DS51, DS125, DS160 and DS161 strobes. Accepts Ikelite, SEA&SEA, and Olympus type fiber optic cords.

For remote slave triggering off another flash without a cable, consider the Optical Slave Converter.

This converter attaches to an Ikelite DS strobe. It is not intended to be attached to a housing and will provide no functionality if attached to an Ikelite bulkhead in a housing.

Fiber Optic Cord Compatibility:

Ikelite Fiber Optic Coiled Cord # 4501

INON Optical D Cable “Non-wireless type” L-Connector

SEA&SEA Fiber Optic Cable (L-type) # 50107

SEA&SEA Fiber Optic Cable II # 50128

Olympus UW Fiber Optic Cable PTCB-E02

Nauticam Optical Fiber Cable # 26211 Nauticam to INON

Nauticam Optical Fiber Cable # 26212 Nauticam to Sea&Sea

 

Selling for $120 AUD / $82 USD + shipping

Located in Melbourne, Australia, but happy to ship worldwide.

 

00126097.thumb.jpg.72b0d1ba9bfa17ad9a7a120b8b474b45.jpg

00126103.thumb.jpg.fcbf1a79acf1b546c1933f514873479f.jpg

00126104.thumb.jpg.95839fe7c46d28790b368667e9d681e8.jpg

Share this post


Link to post
Share on other sites

Sponsors

Advertisements



×
×
  • Create New...